FieldWise Calculator

Post Hole Concrete Calculator

Work out how much concrete a fence or deck post needs, and how deep to dig. Enter the hole size, depth and post size to get cubic feet and the number of 60 lb or 80 lb bags. Switch to the hole depth tab to get a recommended depth from the height of your fence above ground.

Concrete per hole...
Total concrete...
Total concrete...
Bags to buy...

Understanding the inputs

diameter
The width of the round hole, in inches. A common rule is a hole about three times the width of the post, so 10 to 12 inches for a 4x4.
depth
How deep the hole is dug, in inches, measured from ground level to the bottom of the concrete. Use the hole depth tab if you are unsure.
postWidth
The side of the square post, in inches. A 4x4 is actually 3.5 inches and a 6x6 is 5.5 inches. Enter 0 to ignore the post volume.
posts
How many identical holes you are filling. Totals scale directly with this number.
bagSize
An 80 lb bag yields about 0.6 cubic feet of mixed concrete and a 60 lb bag about 0.45 cubic feet, the same yields used by our concrete calculator. Check the yield printed on your bag.
height
The height of the fence or post above ground, in feet. The calculator adds the buried length to give the total post length.

Typical buried depth by fence height (one third of the post underground)

Height above groundHole depthTotal post length
4 ft24 in (2 ft)6 ft
5 ft30 in (2.5 ft)7.5 ft
6 ft36 in (3 ft)9 ft
8 ft48 in (4 ft)12 ft

Frequently asked questions

How deep should a fence post hole be?

A common rule is to bury about one third of the post, which means the hole depth is half of the height above ground. A 6 ft fence needs a hole about 36 inches deep, so the post is 9 ft long. Use at least 24 inches for short fences, and go deeper if your local frost line or loose soil requires it. Check your local building code.

How many bags of concrete do I need for a fence post?

For a 10 inch wide hole, 30 inches deep, with a 4x4 post (3.5 inches), one hole takes about 1.15 cubic feet of concrete. That is about 2 bags of 80 lb concrete (1.92 bags) or 3 bags of 60 lb concrete (2.56 bags). Multiply by the number of posts for a whole fence, then round up. Yields vary a little by brand. Budgeting the whole job? The fence cost calculator estimates installed cost and post count.

How do I calculate concrete for a fence post?

Find the volume of the round hole, pi times the radius squared times the depth, then subtract the volume of the post, its width squared times the depth. Divide the cubic inches by 1,728 for cubic feet, then divide by the bag yield. For a 10 inch by 30 inch hole with a 4x4: 2,356 minus 368 is 1,989 cubic inches, or 1.15 cubic feet.

How wide should a post hole be?

A common guideline is a hole about three times as wide as the post. For a 4x4, that is 10 to 12 inches across. A wider hole uses much more concrete: a 12 inch hole at the same depth takes about 1.5 times as much as a 10 inch hole (after subtracting the post). Mixing from scratch instead of bags? See the sand and cement calculator.

How much gravel should go under a fence post?

Many builders add about 6 inches of compacted gravel at the bottom of the hole so water can drain away from the post end. If you do, dig 6 inches deeper than the burial depth. The dig depth output on the hole depth tab includes this.

Does frost depth change how deep fence posts go?

Yes. In cold climates, posts that sit above the frost line can be pushed up as the ground freezes. Many codes require footings below the local frost depth for decks and some fences. The one third rule is a general guide, so confirm local frost depth and soil conditions before you dig.

Related calculators