FieldWise Calculator

Tile Calculator

Use this tile calculator to work out how many tiles to buy for a room before you order. Enter the room size in feet and the tile size in inches. It shows your room's square footage (sq ft), then adds a waste allowance for cuts and breakage.

Room area...
Tiles needed (exact)...
Tiles to buy (with waste)...

Understanding the inputs

roomLength
The longer wall of the room you're tiling, in feet.
roomWidth
The shorter wall of the room you're tiling, in feet.
tileLength
The longer edge of a single tile, in inches. Check the box or spec sheet, not just the "nominal" size.
tileWidth
The shorter edge of a single tile, in inches.
groutGap
Standard grout lines run 1/8" (0.125) to 3/16" for floor tile, and as thin as 1/16" for large-format tile.
waste
Simple straight-lay rooms need less extra tile; diagonal layouts, small rooms with lots of cuts, or a complex floor plan should use a higher waste allowance.

Tiles per square foot by tile size

Tile size (in)Tiles per sq ftTiles for 100 sq ft (before waste)
6 x 64.00400
8 x 82.25225
12 x 121.00100
12 x 240.5050
16 x 160.5657
18 x 180.4445
24 x 240.2525

Frequently asked questions

How do I figure out square footage for tile?

Figuring tile square footage takes two steps. Multiply the room's length by its width (both in feet) to get the room's square footage. Then divide by one tile's area (in square feet) to get the number of tiles needed before waste. This tile square footage calculator does both steps for you and adds a waste allowance on top.

How many tiles do I need per square foot?

It depends on the tile size: a 12 x 12 inch tile covers exactly one square foot, so you need one per sq ft, while a 6 x 6 inch tile needs four. See the table above for common sizes, or use the tiles calculator at the top of the page to include grout lines and waste.

How much extra tile should I buy?

A common rule of thumb is 10% extra for a straightforward, straight-lay installation. Diagonal layouts, small or irregularly shaped rooms, and patterned installs typically need 15–20% extra to cover cuts and breakage.

Related calculators