FieldWise Calculator

Parallel Resistor Calculator

Find the equivalent resistance of resistors connected in parallel. Enter up to six resistor values in ohms and leave the unused boxes empty. The calculator uses the parallel resistor formula, 1/Req = 1/R1 + 1/R2 + ..., and shows the single resistance that could replace them all.

Equivalent resistance (ohms)...
Resistors used...

Understanding the inputs

r1
Resistance in ohms. For kilohms, multiply by 1,000 (4.7 kilohms is 4700). Leave a box empty to skip it. Empty and zero boxes are ignored.
r2
The second resistor in ohms. At least two values are needed for a parallel combination.
r3
An optional third resistor in ohms.
r4
An optional fourth resistor in ohms.
r5
An optional fifth resistor in ohms.
r6
An optional sixth resistor in ohms.

Common parallel resistor combinations

ResistorsEquivalent resistance
100 ohm and 100 ohm50 ohm
100 ohm and 220 ohm68.75 ohm
47 ohm and 100 ohm31.97 ohm
470 ohm and 1,000 ohm319.73 ohm
1,000 ohm and 1,000 ohm500 ohm
Three 10,000 ohm resistors3,333.33 ohm

Frequently asked questions

What is the parallel resistor formula?

For resistors in parallel, the reciprocal of the total resistance is the sum of the reciprocals: 1/Req = 1/R1 + 1/R2 + 1/R3 and so on. Invert the sum to get Req. For 100 ohm and 220 ohm that is 1/(0.01 + 0.004545), which is 68.75 ohm.

What is the formula for two resistors in parallel?

With two resistors you can use the product over the sum: Req = (R1 x R2) / (R1 + R2). For 100 ohm and 220 ohm that is 22,000 / 320, or 68.75 ohm.

What if all the resistors are the same value?

Divide the value by the number of resistors. Three 10,000 ohm resistors in parallel give 10,000 / 3, or 3,333.33 ohm.

Why is parallel resistance always lower than the smallest resistor?

Each resistor adds another path for current, so the total opposition falls. The equivalent resistance is always below the smallest single resistor, which is a handy sanity check on your answer.

How do I find the current through each parallel resistor?

Every resistor in a parallel branch sees the same voltage, so the current through each one is that voltage divided by its resistance (I = V / R). The branch currents add up to the total current. For cable sizing at higher currents, use the wire size calculator.

What is the difference between series and parallel resistors?

In series the resistances simply add (R1 + R2 + ...) and the same current flows through all of them. In parallel the voltage is shared and the equivalent resistance is lower than any single resistor.

Related calculators